The Cessna 172 Flighttrainer does not work.

[Freshprince81]

Dear A2 Team
The Cessna 172 Flighttrainer does not work.
I see the graphic of Cessna, however it does not work.
The aircraft can not be started, it does not respond to the elevator, the rudder, the aileron .......
I use the Lockheed prepar3Dv3 with these all the airplanes work. (SaitekYoke, Saitek Rudder)
Can you help me?

regards
Martin

[Lewis - A2A]

Hello Martin,

welcome to the forums. Can you give us some further information about the exact issue you are encountering and more information about your setup. For example have you done a pre-flight to check the aircraft is fit for flight prior to start?

What control hardware/software are you using aside from what you have mentioned. Are you an FSUIPC user and if you are have you turned controls off in the sim as this would be why your controls are not working.

Are your settings in the sim set as per the manual?

thanks,
Lewis

[Nick - A2A]

Hi Martin,

One other question: do you have the legacy FSX SimConnect client installed on your machine? It's needed for the A2A add-ons to communicate with P3D. I've borrowed the image below from from forum member "Poppet", but this is what you should be doing to install SimConnect...



Thanks,
Nick

[Freshprince81]

Hello Nick,

Thank you very much!
That was the problem.

regards
Martin

[Nick - A2A]

You're welcome Martin. Glad you're back in business and thanks for letting us know.

Nick

[Lewis - A2A]

Good to hear, happy flying in the virtual skies

thanks,
Lewis