Page 1 of 1

PFC Yoke Prepar 3D 4.2 possible increase n roll sensitivity?

Posted: 15 Feb 2018, 15:07
by motoadve
Very sluggish
Calibrated it in Windows, in game and at full sensitivity and feels like a 747

In Airplane CFG file I increased aileron sensitivity from 1 to 3 and still sluggish (didnt feel change)

Is there a way to make it more responsive?

I have a real 182 and can fly it with 2 fingers, want to achieve the same feeling here.

Re: PFC Yoke Prepar 3D 4.2 possible increase n roll sensitiv

Posted: 15 Feb 2018, 15:22
by Oracle427
What are your sim sensitivity settings configured to? The showers should be full right (max) with no null zones.

I don't own the A2A 182, but the max roll rate at various speeds of the A2A 172 matches perfectly with the max roll rate of the 172S I compared it to.

I would think it would be the same for the 182 assuming the sim is set up as required.

I did get to fly a 170 for the first time a coupe of weekends ago. That has an abysmally slow roll rate, so the model aircraft can make a big difference. What year is your 182? I believe the wings were changed slightly in the mid 70s.

Lastly, don't modify the .cfg file. A2A uses chain coding outside ofv the sim engine. Changing parameters in any files can cause unexpected behaviors.

Re: PFC Yoke Prepar 3D 4.2 possible increase n roll sensitiv

Posted: 15 Feb 2018, 15:46
by motoadve
I had it perfect in Prepar 3D V3

Cessna 182 P

Re: PFC Yoke Prepar 3D 4.2 possible increase n roll sensitiv

Posted: 15 Feb 2018, 15:49
by Oracle427
Check the axis sensitivity settings.

Re: PFC Yoke Prepar 3D 4.2 possible increase n roll sensitiv

Posted: 15 Feb 2018, 15:59
by motoadve
Oracle427 wrote:Check the axis sensitivity settings.

They are at full sensitivity

Re: PFC Yoke Prepar 3D 4.2 possible increase n roll sensitiv

Posted: 17 Feb 2018, 07:17
by Lewis - A2A
nothing change with our software between the versions so you will want to contact PFC as I believe they have there own software for this sort of thing that bypasses the built in config.

thanks,
Lewis

Re: PFC Yoke Prepar 3D 4.2 possible increase n roll sensitiv

Posted: 17 Feb 2018, 08:33
by motoadve
PFC say its Prepar 3D software causing this.
And actually it is because works fine in Aerofly

Re: PFC Yoke Prepar 3D 4.2 possible increase n roll sensitiv

Posted: 17 Feb 2018, 09:36
by Lewis - A2A
So you'll want PFC to update there controllers for the latest P3D?

Just a thought though, P3D has two ways to set controllers up, have you tried both as normally only one works best for a given hardware.

http://www.prepar3d.com/forum/viewtopic.php?t=120847

thanks,
Lewis