Rudder Full Left
Rudder Full Left
I was going to do a flight , but when I checked flight controls. The rudder pedal stayed full left. I have to push full right to get back to neutral. Maint. Hangar says the plane is fine. I use fsuipc and a saved spadnext online profile I've been using for a while now. I recalibrated in fsuipc, and in p3dv4. All assignments are disabled in p3d, but I thought to calibrate anyways. Didn't work. I loaded another A2A plane (P-51...Thank You, by the way.) and the rudder worked as it should. I am using rudder pedals, not keyboard or twisting joystick. I appreciate any help.
-Morte
- Nick - A2A
- A2A Captain
- Posts: 13734
- Joined: 06 Jun 2014, 13:06
- Location: UK
Re: Rudder Full Left
Hello Morte,
Sounds like a control conflict somewhere between P3D, FSUIPC and SPAD.neXt. I recommend you double-check any aircraft-specific profiles you have saved for the Comanche if this is the only aircraft affected.
Thanks,
Nick
Sounds like a control conflict somewhere between P3D, FSUIPC and SPAD.neXt. I recommend you double-check any aircraft-specific profiles you have saved for the Comanche if this is the only aircraft affected.
Thanks,
Nick
Re: Rudder Full Left
Hi Nick,
Thanks, my calibration in fsuipc was messed up in the center setting. Didn't notice it last night. I may not have rechecked it again for who knows how long. Much appreciated.
Thanks, my calibration in fsuipc was messed up in the center setting. Didn't notice it last night. I may not have rechecked it again for who knows how long. Much appreciated.
-Morte
- Nick - A2A
- A2A Captain
- Posts: 13734
- Joined: 06 Jun 2014, 13:06
- Location: UK
Re: Rudder Full Left
You're welcome Morte - good to hear you found the culprit and thanks for the update.
Nick
Nick
Who is online
Users browsing this forum: No registered users and 14 guests