Page 1 of 1

Wierd Rudder Behaviour in Comanche

Posted: 30 Sep 2018, 14:16
by Gabe777
1. Rudder not moving at all until engine power set high.... makes steering during taxi difficult.

2. Barely any rudder input required in turns, unless it is much steeper than the standard rate marked line.

Is this usual ?

Thnx

Re: Wierd Rudder Behaviour in Comanche

Posted: 03 Oct 2018, 04:28
by Caldemeyn
Check autorudder is off and realism settings are 100% (the fin doesn't move when stationary ? )
Check the rudder condition during walkaround and in the hangar
Check your calibration and assignments
Check if you don't engage the default p3d autopilot or yaw damper functions

Re: Wierd Rudder Behaviour in Comanche

Posted: 03 Oct 2018, 08:11
by Gabe777
Hi. Sorry, sorted.

Turned out deadzones on toe brakes needed calibrating in FUZZY UP.

THNX