VOR 2 head issue when GTN 750 installed

[detheridge02]

Disclaimer : I may have been "Accusim'd"

Loving the aircraft and hope some of the new technologies can be incorporated into the the 172,182, Comanche etc

I have a new state aircraft setup with the GTN 750 as NAV/COM 1 and the standard radio unit as NAV/COM2.
The GTN works fine with the HSI in CDI and OBS modes for GPS tracking and ILS approaches.

COM 2 works - although it triggers the GTN to set MIC and MON to COM2 until a transmission has finished (e.g. ATIS tuned on COM 2)

NAV 2 DME works fine, however there is no response on VOR head 2 (the gauge above the light switches). I've checked breakers and run an inspection and nothing is showing.

Is this user error (likely), Accusim (possibly) or an issue (maybe)

Thanks
Dave

[Nick - A2A]

Thanks for the post Dave,

We'll check this, and add to the list for a future update if necessary.

Cheers,
Nick

[Nick - A2A]

NAV 2 DME works fine, however there is no response on VOR head 2 (the gauge above the light switches). I've checked breakers and run an inspection and nothing is showing.

Hello Dave,

Just to follow up on this, I haven't been able to reproduce this issue with my installation so far (using RXP GTN). Please can you verify if the problem still exists your end, and ideally provide a screenshot showing an example. Here's one from my installation.



More info on attaching screenshots here.

Thanks,
Nick

[fleurenf]

Hi Nick,

Could it be an issue with the Flight1 GTN as I note you mention the RXP GTN.

Not sure if Dave has Flight1 or RXP.

[Nick - A2A]

Not sure either, but this topic is from Sept last year and as we haven't heard back, hopefully everything is okay.

Thanks,
Nick