The A2A Simulations Community

Note Always make a backup file and place a copy of you aircraft.cfg and panel.cfg files into it before you make any modification.


After 2 hrs of testing I have found everything you need along with a little extra. Basically you need to make the default boeing 737 panel read (you can find the panel in your fsx file under simobjects/aircraft/boeing 737 and it will be in the panel folder the aircraft will be in the main folder at the bottom)

gauge29=shockwave_lights!SW Lights_taxi_gear, 1,1,1,1 //shockwave light

Before saving the panel again make sure you select:

File
Save as
Change SAVE AS TYPE to all files
Then look for your panel.cfg file and select it and over right it.

Then open you aircraft.cfg file

Modify these line to read as follows:

light.10 = 5, 5.6, 7.28, -1.47, fx_Shockwave_landing_light_narrow // Shockwave light
light.11 = 5, 5.6, -7.28, -1.47, fx_Shockwave_landing_light_narrow // Shockwave light
light.12 = 6, 41.85, 0.0, -6.8, fx_Shockwave_landing_light_small_xenon // Shockwave light
light.13 = 6, 36, 0, -18, fx_shockwave_landing_light_light // Shockwave light


Save the aircraft.cfg file the same way you saved the panel.cfg.

There you have it all fixed and you also have a neat modern xenon for you front gear. You will also not need to turn off taxi light on takeoff because when you raise the gear they automatically go off. If you want the standard gear light just delete _small_xenon and there you have it.

If you have any further questions feel free to email me at mtmike1981@yahoo.com and put a2a questions in the subject and I will get back to you as soon as I can

Thanks and hope this helps




Mike Richard
Mtmikepsl