The A2A Simulations Community

Ok I have noticed with every plane so far, I cannot control the red beacon light and when/if I can it also turns on a white strobe at the tail (mainly noticeable on the Dreamwings Q400); I haven't been able to turn off the red beacon on the PC-12 but that was an issue before adding the 3D lights.

Also with the dreamwings Q400, the landing lights will turn on/off/can be seen from within the panel; but outside view they are either always on or always off even though they might be on or off from within the cokcpit view.

I got the config from here on the forum for the Q400 as well as the PC-12.

I also tested this on another Q400 (not PAD) just to see how it would behave, and I get the same issues as the DW version.

If there's another thread on this, please point me to it; I didn't find it in the search but I'll try many other ways of futile searching.