I know I am new to the B377 forum, so please be patient with me. I have skimmed through the pilots manual, and I pretty much
know how the pop up menu works, as I own the A2A B-17. But somehow I can't find how to enable the flight engineer. Any help
would be greatly appreciated. Thanks in advance, Edmeister
How do I enable the flight engineer?
-
- Senior Master Sergeant
- Posts: 2286
- Joined: 05 Nov 2013, 10:48
- Location: Oksboel, Denmark
Re: How do I enable the flight engineer?
I'll highly recommend that you take the time to read and understand the manual((s) if you have COTS)
Kind Regards
Tomas
Sim: FSX SE
Accu-Sim aircraft in my hangar:
C172, C182, P51 Civ, P51 Mil, B17, Spitfire, P47, B377 COTS,
J3 Cub, T6, Connie, P-40, V35B
A2A Accu-Sim Avro Lancaster Loading:............0.000003% complete, please wait.
Tomas
Sim: FSX SE
Accu-Sim aircraft in my hangar:
C172, C182, P51 Civ, P51 Mil, B17, Spitfire, P47, B377 COTS,
J3 Cub, T6, Connie, P-40, V35B
A2A Accu-Sim Avro Lancaster Loading:............0.000003% complete, please wait.
Re: How do I enable the flight engineer?
Thanks. The popup menu (shift3) was only showing the top two thirds, it was not showing the bottom third of the screen, which is
where the flight engineer is located. I dragged the top of the popup menu toward the top of my computer screen and it appeared.
I hope this helps someone else who might encounter this problem. And I will continue to read the manual. Thanks again, Edmeister
where the flight engineer is located. I dragged the top of the popup menu toward the top of my computer screen and it appeared.
I hope this helps someone else who might encounter this problem. And I will continue to read the manual. Thanks again, Edmeister
Who is online
Users browsing this forum: No registered users and 3 guests