Page 1 of 1

Logitech G940 mapping problem

Posted: 26 Mar 2011, 13:38
by DennyBoy
Hi !

I´m just bought the Logitech G940 Flight System.

Mapping the axes and buttons whas a brise in FS9, FSX, RoF and CFS 2.

But in BoB II I run into problem.

Well - BoB indicated 3 separate devices (same for the other flightsims).

But when I mapping expl joystick and save. I have the same axes in the throttle axes

"Throttle 1=Elevation Throttle 2 Ailerons" I clear these axes and save. with the result

that the joystick axes not funktion.

I have cleared all Buttons for keyboard, "except the buttons I have mapped to

keyboard "and for joystick, throttle and pedals.

I mapped everiting from scratc, firts the joystick and save, throttle and save, pedals

and save.

When I after look at the joystick I have again axes for throttle, rudder, so nothing

works, no response from the throttle. alierin and rudder, The firebutton of the guns is

the only working.

I´m wonder if any how have the G940 devices have the same problem in BoB II

Have the game patched to v2.11 with multiskin

Best Regard
DennyBoy

Re: Logitech G940 mapping problem

Posted: 26 Mar 2011, 14:21
by Buddye
Hi Danny, welcome to BOBII and the BOBII forum and community.

Sorry I do not have a G940.

Have you looked at the "controller section" of the BOBII User Manual. Have you read this thread:

http://a2asimulations.com/forum/viewtop ... =17&t=2241