I have installed the Spitfire & AccuSim directly into P3D 3.4. The installation ran without problems, as did the subsequent updates.
However - shift7 tells me that I can only enter the hangar when I am on the ground with the engine off - which I am.
Shift4 allows me to update some of the quantities, but not fuel - which is at 100% despite the fuel gauge in the cockpit showing empty.
And, despite following the start-up flow carefully the engine doesn't start - which may be because I don't hear the starter cartridge going off.
The Piper Cub appears to be working perfectly for what it's worth. And yes, I do know that that is a relatively simple simulation, wheres the Spitfire is a very complex one.
So - has anybody managed to get the Spitfire working correctly in 3.4 - & if so, what steps did you take to make it happen?
Thanks,
Bernie
Problems with Spitfire in P3D 3.4
- bladerunner900
- Senior Master Sergeant
- Posts: 1991
- Joined: 17 Aug 2008, 14:59
- Location: South Wales
Re: Problems with Spitfire in P3D 3.4
Hello sir.
Have a read of this thread and all will be made clear. Pay particular attention to the requirement for at least one P3D native GA model from A2A.
http://www.a2asimulations.com/forum/vie ... 78&t=58285
Cheers.
Steve
Have a read of this thread and all will be made clear. Pay particular attention to the requirement for at least one P3D native GA model from A2A.
http://www.a2asimulations.com/forum/vie ... 78&t=58285
Cheers.
Steve
Re: Problems with Spitfire in P3D 3.4
Problem solved!
I uninstalled it, reinstalled, ran all of the latest updates & now it appears to be working fine.
Now - to try the P51!!
Thanks for the help.
Bernie
I uninstalled it, reinstalled, ran all of the latest updates & now it appears to be working fine.
Now - to try the P51!!
Thanks for the help.
Bernie
- bladerunner900
- Senior Master Sergeant
- Posts: 1991
- Joined: 17 Aug 2008, 14:59
- Location: South Wales
Re: Problems with Spitfire in P3D 3.4
That is good news. I could do with some at the moment.
Who is online
Users browsing this forum: No registered users and 22 guests