The A2A Simulations Community

Hi all,
During a flight right now i figured out, that each time I swap between fullscreen and windowed the MP and as a result the torque are jumping upwards for a second, then they are going to the normal level. I have the same problem when I minimize the FSX.
Do you have a Idea? If you ask me its not good for the engines when the torque goes up to red mark
Regards
Alex

Hi,

It could just the engine behavior as this happens particularly at high power. I have checked that it is not controller induced, so it is something in the logic (either deliberate or accidental - we need Scott's input here).

Best regards,
Robin.

_________________
A2A/AccuSim. 'nuff said!

Yeah, i got the same behaviour. But when you pause the sim, swap between minimized etc and unpause again, it won't happen. At least on my system^^

Cheers

General question:

What is the reason switching from FSX fullscreen mode to windowed mode? FSX do not like that and i do not recommand that to you. For example I only use FSX in permanent winwowed mode due to other programms running in background like teamspeak, ASE, IVAO . For getting access to that programms using FSX in windowed mode is the better choice.

_________________
FSX SP2 DX9.Addons:FSG2010,REX OD, AS2012, PMDG, DA Do27, Dodosim, A2A accusim all, Katana4X,Coolsky DC9 Classic, Swiss Pro,ORBX all, Fly Tampa, DRZEWIECKI DESIGN, FS Dreamteam, FranceVFR Haute Normandie 3D...

Hi,
I hate the windowed mode during approach and so on. Also because of the windows 7 taskbar It kills my nerves
I have no problems in general with the switsching. It works perfect, the only issue I have is the torque and MP jumping
Regards
Alex