Hi all,
I have installed the P-40 into P3D, and it all seemed to install fine.
I have started the engine etc and taxied and it seems to sink into the ground and float and smash to pieces in the hangar.
I have tried several airfields and have the same problem.
Does anyone have any ideas?
Thanks
Dan
P.S I know that the P4- etc are not designed for P3D but hoped to install into P3d as many have...
P40 in P3D
Re: P40 in P3D
Hi,
Set "mesh complexity" under Settings to 10 and test it.
Check this article: http://a2asimulations.com/forum/viewtop ... 94&t=50497
Cheerz,
Will
Set "mesh complexity" under Settings to 10 and test it.
Check this article: http://a2asimulations.com/forum/viewtop ... 94&t=50497
Cheerz,
Will
Bonanza, Skylane, Skyhawk, Cherokee, Cub, Texan, Mustang, Warhawk, Spitfire, Flying Fortress
Re: P40 in P3D
Hi Will,
Thanks a lot... I will look into this. I did manage a flight last night without the issue but didn't do anything different...
Thanks for the heads up!
Dan
Thanks a lot... I will look into this. I did manage a flight last night without the issue but didn't do anything different...
Thanks for the heads up!
Dan
Who is online
Users browsing this forum: No registered users and 21 guests