The A2A Simulations Community

Hello guys and gals,

So It's been a while since I last flew the P-40. Took her for a spin today and noticed during ground run-up that at 2200 RPM at Auto-Rich mixture I'm getting only approximately 20 inches of manifold pressure, regardless whether it's a new (0.0 hours) or slightly used engine (~10 hours). Manual says that I should be getting 26 inches at 2200 RPM.

I have the 1.4 update installed, even went and reinstalled every Accu-Sim aircraft I have (right clicking and selecting "Run as administrator") but sill the same issue. The procedure was the following:

1. Install Spitfire
2. Install Spitfire Accu-Sim
3. Install P-40
4. Install P-40 Accu-Sim
5. Install P-51
6. Install P-51 Accu-Sim
7. Install 1.4 Core Update

Is that correct, is 1.4 Update cumulative? Anyone else have this issue?

That installation looks correct. What altitude were you operating at?

_________________

Hey Cody,

The airport elevation is 308 feet.

Cheers,

Hydra

Hydra,

Check the checklists in the 2d panel pilot's notes. This was changed to:
Check mags at 2300 r.p.m. and 25"

I believe the figure we gave in the manual was using a different prop and engine.

Scott.

_________________
A2A Simulations Inc.