Accufeel has stopped working after four years troublefree.

[ncooper]

Hello,

I have had Accufeel since February 2012 and not once has it given me a problem.
Now it has stopped working
I am using FSX Gold and Windows 10.
I have been through the entire FAQ sections for both versions 1 and 2 and even tried it in a clean
installation of FSX.
I have sent off the Doctor A2A report too.
Accufeel installs correctly, it appears in the FSX menu and opens.
However, the sliders are all to the left and it seemingly cannot read any of the aircraft.
I have re-installed simconnect with no effect at all.
I have EZDock Camera installed and working and other software, like Plan G can connect via simconnect.
I have run out of things to try, I wonder if you could have a look at the Dr A2A report or offer me any
other suggestions.
many thanks,
Nick.

[Lewis - A2A]

Hello Nick,

what happened to your system between it working and not working? Any new add-ons?

When running the simconnect install did you restart your system?

thanks,
Lewis

[ncooper]

Hello Lewis, thanks for your reply.

To be honest, I'm not quite sure when it stopped working.
I had Simphysics installed and it was working then.
I uninstalled that and replaced it with EZDock camera recently
and of course Windows 10 keeps updating itself.

If I set the parameters for the aircraft manually and switch Accufeel
on, it works just as it should for that session but upon a restart,
none of the settings have been saved and it's off again.
It's as if it can no longer see FSX.

FSUIPC tells me that simconnect is correctly installed and working.

Regards,
Nick.

[ncooper]

Hello Lewis,
It is now working again using a backed up copy of the dll.xml file.
Thanks for your reply.
Regards,
Nick.

[Lewis - A2A]

Okie dokie good to hear.

thanks,
Lewis