The A2A Simulations Community

Have just installed triplehead2go (3 video screens) It works great untill I try to turn on the Bezel management. With the bezel man. program on when I try to start BobII It wont load. If I turn Bezel Man. off BobII loads fine.

The bezel management works fine in FSX and other games any ideas?

Can you use that SW without trippleheadToGo? Is it free?
If so, we could test it.
If not are you prepared to help us by installing test stuff and running it?

Also, other TrippleheadToGo users, do you have the same issue?

Scott has it, I think.

Maybe he can help us out.

_________________
Buddye

Intel I7 920 processor (2.66GHz, 8MB cache), 6GB DDR3 Triple Channel @1333MHz, 1.8GB NVIDIA GeForce GTX 295, Sound Blaster X-Fi PCI Sound Card, Windows 7 Home Premium 64 Bit , CH Fighter Stick & Pedals ,TrackIR4 Pro thanks to BobII crew.

Any new info? Any success? I am going to get mine working later this week, any info appreciated, thanks.

Ah, ok.
I just chatted to Scott, he indeed does have it but he is on businesstrip right now. He can test next week.

Zorro I cant recomend Triplehead2go highly enough. Of all the toys that I have bought for sim addiction this is by far the best. It worked first time out of the box for me the only problem I had with BobII was I had not adjusted my FOV to 110 (I may experiment with a larger number) once I set it for 110 it worked great.

I later tried to turn on the Bezel managment with the digital version which allows you to adjust the edges between the screens so that lines look straight. It worked great in FSX but then when I came back to BobII It would not load, as soon as I turned off the program for the bezel man. It would load normal.

Its such a minor problem I hardly notice and dont want to spend a lot of time trying to figure it out. Just hopeing that someone might have an easy answer.

That is good to know. Going to get my rig working later this week as soon as i get some brackets to install the monitors. Hopefully it will make me air sick. I could have bought a big single monitor, but opted for 3 monitors for the surround effect.

I experimented a little with my triple head bezel management program and found when I try to start BobII with BM on, BobII shows up on my task bar but wont open. If I then try to restart Bob while its still on my task bar it will then start OK and the BM works great the only problem is when I quit BobII It is still on my task bar and the only way to close it is to go into Task Manager.

Back to not working with the bezel management program on. Turned program off Bob loads OK.

With Bezel Management on the outer panel width resolution is reduced by the width of the frame on the video panels. My guess is the reduced width throw off Bob when it loads.