The A2A Simulations Community

I have just purchase the product and trying to use it with Wilco Feelthere 737 I experience a strange behaviour.

When I have the autopilot activated and reach the set altitude the aircraft badly jumps up and down and the only way to stabilize it again is to turn off Accu-Feel.

If after I still try to turn on Accu-Feel the bouncing starts again until I till turn off it.

Any help will be appreciated

Thanks and best regards

Joe

Does anyone else have this aircraft? If not, we'll see if we can get it and test.

Scott.

_________________
A2A Simulations Inc.

No ideas?

I would use it, but in this way it is impossible !!!

Thanks

AOA slider?

_________________
A2A Facebook for news live to your social media newsfeed
A2A Youtube because a video can say a thousand screenshots,..
My twitter for my own twitter and random A2A insights

I have not access to my PC at home now, but I did not changed any slider respect what presented by default.

Check your mach limit slider too.

The sliders values are: Stall AOA 15,4 - VNE (max mach) 0,82 - VNE (max IAS) 345

Still nothing???

A little more of support and attention should be given !

Thanks

Did you try changing your AOA slider?

It sounds like either Accu-Feel wont work with the aircraft in question, or more likely that you were trying to high a AOA angle and triggered the AOA effect. Change the AOA slider to cure this.

_________________
A2A Facebook for news live to your social media newsfeed
A2A Youtube because a video can say a thousand screenshots,..
My twitter for my own twitter and random A2A insights

I have tried to move the OAO slider in all the ways, but nothing changes:just reached thge autopilot altitude the aircraft strts to jump up and down.

Very disappointing