The A2A Simulations Community

Hi, just ran into this and not with other aircraft as of yet, otherwise it's been working great.
Normal climbout with the stock FSX 737-800 aircraft and almost immediate buffeting to the degree of loss of lift and eventual crash.
As a compairson, no issues observed when flying the A2A B17 or B377, LionHeart Kodiak, FSX Baron58 or FSX Learjet. Haven't tried any others yet.

I've tried varying the AOA from nothing to 25 and I'm not seeing any changes. It acts like and feels like its related to this, but I'm unable to resolve it. Appreciate some help in resolving this.

Mark

Mark,

This is an odd issue, as we've tested it plenty with the default 737.
Did you try disabling Accu-Feel completely for the 737?

Scott.

_________________
A2A Simulations Inc.

Yes, it's only option at this point to let the aircraft fly. If I disable AccuFeel during flight with the 737 the issue goes away. Reenable it and the problem returns. Find it odd myself, that it's only this aircraft that I've run into this and again, it made no difference where I set the AOA as it exhibits a severe buffeting and wind noise as though my angle of attack were to high for the airspeed, but this still occurs even with the airspeed over 200 IAS.

Asking others that I know that have AccuFeel to try with the same aircraft and see what their results are. I can't think any mod that could have been done that would have affected this particular aircraft to exhibit this behavior.

Mark

mjl,

Why do you assume it has to do with the AoA slider? Where do you have the 2 Vne Sliders? What happens when you move both Vne sliders all the way to the right?

_________________
1)i7 980x 4.35 ghz, gtx 470s SLI, Matrox th2go, Creative x-fi
2)i7 2600k, Gigabyte z68x, gtx 285s sli

The sliders are at what I assume to be the default settings. Vne (No Exceed) are at .81 Mach and 340 IAS. Just a slight climb or angle of attack with a IAS of 200+ I had buffeting, so I don't see how those would come into play.

So I loaded the flight and double checked the Vne settings anyway and retested this morning. Today the aircraft flies just fine with AccuFeel. Yesterday when this first occurred I did a reboot of the Pc and restarted FSX and the issue was still there. Today, all I did was start up FSX (shut down from yesterday), verified that AccuFeel was enabled and the settings for AOA and Vne's were at default settings and did a take off like yesterday from KSEA.
Working fine from any other random location as well. Not sure why I was seeing this yesterday nor why the reset of the pc and fsx did not clear it up yesterday, but today the issue is gone. Hopefully it stays gone, or I can figure out what triggered it to happen.


Ending on a high note, this was the first and only issue todate that I've had, this product adds alot to the simulation experience, nice job!

Mark