I'm seeing some strange issue. With engine running, all course knobs (OBS, ADF, gyro drift) rotate by 10 degrees. Everything works normally (step is 1 degree) until I start the engine...
Latest update is applied. I'm not sure if something got corrupted with my installation or this is some general problem. P3Dv4 version.
OBS knob step is 10 degrees
- Lewis - A2A
- A2A Lieutenant Colonel
- Posts: 33300
- Joined: 06 Nov 2004, 23:22
- Location: Norfolk UK
- Contact:
Re: OBS knob step is 10 degrees
Hello Jarek,
are you using mousewheel to change the values. Also have you tried a new flight over a saved flight.
thanks,
Lewis
are you using mousewheel to change the values. Also have you tried a new flight over a saved flight.
thanks,
Lewis
A2A Facebook for news live to your social media newsfeed
A2A Youtube because a video can say a thousand screenshots,..
A2A Simulations Twitter for news live to your social media newsfeed
A2A Simulations Community Discord for voice/text chat
A2A Youtube because a video can say a thousand screenshots,..
A2A Simulations Twitter for news live to your social media newsfeed
A2A Simulations Community Discord for voice/text chat
Re: OBS knob step is 10 degrees
yes, I'm using mousewheel. It is a fresh, new sim scenario. Effect is always the same. Once engine is running it switches to 10-degree mode and stays there, even if engine is shut down later.
Edit: Topic is frozen until I will be able to identify the root cause. I was able to confirm that it does not happen every time.
Edit: Topic is frozen until I will be able to identify the root cause. I was able to confirm that it does not happen every time.
Re: OBS knob step is 10 degrees
I was able to reproduce this issue just by moving throttle and mixture rods simultaneously from 100% to 0 (from stop to stop).
Plane was started in a new sim scenario, didn't touch anything except these 2 rods - all switches in off position, fuel selector off.
When plane was loaded, it had both throttle and mixture set to 100%.
Plane was started in a new sim scenario, didn't touch anything except these 2 rods - all switches in off position, fuel selector off.
When plane was loaded, it had both throttle and mixture set to 100%.
- Nick - A2A
- A2A Captain
- Posts: 13771
- Joined: 06 Jun 2014, 13:06
- Location: UK
Re: OBS knob step is 10 degrees
Hi Jarek,Jarek wrote: ↑13 Apr 2020, 11:44 I was able to reproduce this issue just by moving throttle and mixture rods simultaneously from 100% to 0 (from stop to stop).
Plane was started in a new sim scenario, didn't touch anything except these 2 rods - all switches in off position, fuel selector off.
When plane was loaded, it had both throttle and mixture set to 100%.
Unable to reproduce this behaviour here at present. Do you have hardware axes assigned for both the throttle and mixture control?
Thanks,
Nick
A2A Simulations Inc.
Re: OBS knob step is 10 degrees
Hi Nick,
Nothing is set in the A2A Cherokee Input Configurator.
In P3D, this is pretty simple setup - Z Axis assigned to "Mixture axis" and X Axis to "Throttle axis"
I will send you link with video in PM, I have this recorded.
Nothing is set in the A2A Cherokee Input Configurator.
In P3D, this is pretty simple setup - Z Axis assigned to "Mixture axis" and X Axis to "Throttle axis"
I will send you link with video in PM, I have this recorded.
Who is online
Users browsing this forum: No registered users and 13 guests