Question concerning use of VR and GTN 750

Post any technical issues here. This forum gets priority from our staff.
new reply
Jim Upton
Airman Basic
Posts: 4
Joined: 31 Aug 2017, 21:25

Question concerning use of VR and GTN 750

Post by Jim Upton »

I have these 3 planes; Comanche 250, Bonanza V-Tail, and just now the C182 Skyplane.
I use Flight1’s GTN 750 in all 3 planes, and I make use of VR in all 3 planes.
Inside the VR cockpit, I like to click on the GTN and have it pop-up.
With the Comanche and Bonanza, I have no issues.
The pop-up appears within the cockpit space, in a reasonable location, and I can click on the buttons and everything is fine.

However, with the C182, the pop-up appears outside the windshield of the plane, and I cannot click on it.
Because GTN and VR work fine with the other two planes, that is why I am asking the question here.

For the C182, how can I get the GTN to pop-up inside the cockpit like it does with the Commanche and Bonanza?
And for all 3 planes, how can I change the location of the pop-up window?

Its locations changes a bit from one time to another, and I would like to put it where I want it.
One other small thing I noticed with the C182 and GTN 750 in VR, if I click on the Direct-To button, it does nothing.

I am using Prepar3d V5. For each plane I have checked for updates and the utility says I have the latest.
Looking around at posts involving GTN, I did see a mention of enabling “legacy mode” in GTN_config.ini.
When I looked, it was already set to a value of 1.

Any help appreciated.
All these planes are great, BTW.

Thanks,
Jim


System:
Nvidia RTX 2080 Ti
AMD 3900x
32GB Memeory
SSD hard drives.
Oculus Rift VR.

Software:
Prepar3d V5 w/Hotfix 2
Orbx Scenery
Active Sky P3D(V5)

new reply

Return to “C182 Skylane Tech Support”

Who is online

Users browsing this forum: No registered users and 5 guests