I had to reinstall FSX. When I load my a2a planes and it only accepted two, they are incomplete. Example no pait or only half of the plane. I tried to update but it only found the two I had in the new FSX and it still unloaded only partial planes.
How can I get new copies of the plane, or is that possible?
Can't load any a2a planes in New fsx after crash
- Nick - A2A
- A2A Captain
- Posts: 13805
- Joined: 06 Jun 2014, 13:06
- Location: UK
Re: Can't load any a2a planes in New fsx after crash
flyer1974,flyer1974 wrote: ↑05 May 2020, 11:02 I had to reinstall FSX. When I load my a2a planes and it only accepted two, they are incomplete. Example no pait or only half of the plane. I tried to update but it only found the two I had in the new FSX and it still unloaded only partial planes.
How can I get new copies of the plane, or is that possible?
You seem to keep posting the same question in different topics but not reading the replies which makes it a bit difficult to help. Please see my response here.
Thanks,
Nick
A2A Simulations Inc.
Re: Can't load any a2a planes in New fsx after crash
Ok I went back and pulled up my original order of each plane. I then installed a couple in FSX. They loaded but again there was no fuselodge and the pilot was out of the plane and laying down in front of the cabin? I went to your updater and updated the planes in fsx but with no improvement. I love these planes and do not use any other. Any other ideas?
- Nick - A2A
- A2A Captain
- Posts: 13805
- Joined: 06 Jun 2014, 13:06
- Location: UK
Re: Can't load any a2a planes in New fsx after crash
Did you try installing the Microsoft FSX service packs as I suggested in the linked post?
Thanks,Nick - A2A wrote:Sounds like you may be using the original disk edition of FSX rather than the Steam version or a copy with the Acceleration pack upgrade? In the case, you'll need to download and install both the free service packs from Microsoft. Download links are below:
SP1: https://www.fileplanet.com/archive/p-75 ... te-English
SP2: https://www.microsoft.com/en-gb/downloa ... px?id=8986
Also, please run the Accu-Sim update which is available here.
Nick
A2A Simulations Inc.
Who is online
Users browsing this forum: No registered users and 23 guests