1/. The screenshot taken were right after starting engines.alan CXA651 wrote: ↑24 Jul 2020, 00:53 Hi trisho0.
The photo of the engineers lower panel , and part of top panel , shows something i have not seen before .
1/. when was the screenshot taken , I.E. how long after starting the engines .
2/. was you or the engineer controlling the engineers panel.
3/. engines 2 and 3 show oil cooler flaps almost closed.
4/. fuel flow gauges not showing any fuel flow.
5/. engine cyl temps are not showing any temps , so if engines have only just started , take another screen shot after they have got to operating temp .
6/. manifold gauges not showing any reading , your RPMs need to be raised a little bit.
7/. engines 2 and 3 fuel pressure lights on the upper engineers panel are on , could you do a screen shot of upper panel as well as lower panel.
8/. could you do a screen shot of shift+4 please.
9/. how are you controlling the aircraft , I.E. do you go through FSUIPC or direct from the sim , and what controllers do you use , i have CH yoke/rudder peddles/and two quad throttles going through FSUIPC and some controls set up via A2A connie configurator.
regards alan.
2/. I don't use FE, I control the panel.
3/. Should be open the oil cooler flaps or closed? How to open or close?
4/. What action should be done?
5/. The engines just started.
6/. To raise RPM up is done via Propeller Governor Switches, right?
7/. The movie clip is posted revealing the panel.
8/. The movie clip is posted showing such.
9/. I don't touch FSUIPC but registered. I use KBsim joystick controller,
I made a movie clip showing how I start Connie engines and I might be doing something wrong? Here it goes ...
https://drive.google.com/file/d/1RDHtm_ ... sp=sharing