Going to P3D
Re: Going to P3D
I am going to do the same tomorrow morning.
Going to install it on my 2 TB E drive which is completely empty. Question...does the installation of p3dv5.2 with HF1 only require clicking on the single download link and following the instructions? P3d has never been on this pc. I currently have FSX:SE on a different drive.
Going to install it on my 2 TB E drive which is completely empty. Question...does the installation of p3dv5.2 with HF1 only require clicking on the single download link and following the instructions? P3d has never been on this pc. I currently have FSX:SE on a different drive.
- Skycat
- Senior Master Sergeant
- Posts: 2192
- Joined: 11 Nov 2006, 16:15
- Location: Great Falls Army Air Base, Montana
Re: Going to P3D
P3D downloads are somewhat confusing at first glance. There is the full package that has everything you need; and there are smaller downloads for if you have slow or unreliable internet / or just need to update P3D within the version series you own. Either download the full package and install from there; or download all of the smaller zips and extract to a common folder until you have everything collected in one place, and then use the installer(s).
Sorry, I'm typing from my phone because I'm not near my PC.
Sorry, I'm typing from my phone because I'm not near my PC.
Pax Orbis Per Arma Aeria
- bladerunner900
- Senior Master Sergeant
- Posts: 1991
- Joined: 17 Aug 2008, 14:59
- Location: South Wales
Re: Going to P3D
As of date of this post, you should download the full package which gives you v5.2.22.27615. This will include HF1. It is a 23.1 GB zip file. When extracted you run the Setup_Prepar3D.exe file. I use the Free Download Manager plugin for large downloads.
Steve
Steve
Re: Going to P3D
Skycat and bladerunner...Thanks for the information.
Going to download in a few minutes.
Going to download in a few minutes.
Re: Going to P3D
Successfully Got p3d v5.2 installed and running.
Now to remap my controls and hopefully set them up exactly as in FSX.
Now to remap my controls and hopefully set them up exactly as in FSX.
Who is online
Users browsing this forum: No registered users and 70 guests