COTS AccuSim and Time Compression?
-
- Airman Basic
- Posts: 1
- Joined: 30 Dec 2020, 04:10
COTS AccuSim and Time Compression?
I'm just curious if how much of a problem time compression would create with the B377 using COTS. I'm talking about 2X or 4X only. I realize that a lot of folks feel that to use TC is blasphemous but I find the part between take off and landing to be a bit of a bore. This post is not meant to discuss the plus or minus points of time compression but rather how it would impact the AccuSim and Cots from a technical aspect. Thanks.
-
- Senior Master Sergeant
- Posts: 2439
- Joined: 15 Mar 2016, 08:23
Re: COTS AccuSim and Time Compression?
Hi BlakeLouis.
Time compression is not advisable with any A2A aircraft , it messes them up in different ways , i personally will not fly any aircraft with time compression , no matter how long the flight.
regards alan.
Time compression is not advisable with any A2A aircraft , it messes them up in different ways , i personally will not fly any aircraft with time compression , no matter how long the flight.
regards alan.
-
- Senior Master Sergeant
- Posts: 2286
- Joined: 05 Nov 2013, 10:48
- Location: Oksboel, Denmark
Re: COTS AccuSim and Time Compression?
Copied from another thread:
The Stratocruiser manual doesn't mention time compression, but in other manuals under Quick Flying Tips you'll find:
"Using a Simulation Rate higher than 4X may cause odd system behavior."
The Stratocruiser manual doesn't mention time compression, but in other manuals under Quick Flying Tips you'll find:
"Using a Simulation Rate higher than 4X may cause odd system behavior."
Kind Regards
Tomas
Sim: FSX SE
Accu-Sim aircraft in my hangar:
C172, C182, P51 Civ, P51 Mil, B17, Spitfire, P47, B377 COTS,
J3 Cub, T6, Connie, P-40, V35B
A2A Accu-Sim Avro Lancaster Loading:............0.000003% complete, please wait.
Tomas
Sim: FSX SE
Accu-Sim aircraft in my hangar:
C172, C182, P51 Civ, P51 Mil, B17, Spitfire, P47, B377 COTS,
J3 Cub, T6, Connie, P-40, V35B
A2A Accu-Sim Avro Lancaster Loading:............0.000003% complete, please wait.
Who is online
Users browsing this forum: No registered users and 16 guests