The A2A Simulations Community

Hi there!

I'm repainting my C182 and I can't find how to repaint landing gear legs ...

Where is it on in the C182 Paint Kit ?

Is there a "MAP" describing the textures and to know what it is ?

Thanks for your help !

Here they are, highlighted in red.



Steve.



Small parts layout

Thank you Steve ! They were under my eyes ...

External parts are now most identified ... Just one thing still missing :



I've painted many parts with different colors to highlight it ... No luck ....

Have a great Day !

That is a shadow. It's on the 'Linear Burn' layer.



P.S. I turn every layer off and on, one at a time to identify an item by layer.

I just realised, you probably want what is causing that shadow. Silly me.

It's the Yellow bits this time.

Steve, that's perfect ! Thank you !

I will finish my repaint soon, and i will post it here...

Have a nice day !

My first repaint ... not perfect ...

You'll always remember your first one. Well Done!

i think so !

I've seen one default : at the junction with parts of the fuselage (both sides and underside), a thin white line appears. I've tried to extend concerned selection ...
No luck ... Have you met such things ?

With other models yes, but I haven't done an all over paint for the 182. Usually it's fixed by as you say, stretching the paint for the troublesome part. There could be some stray parts for the bits that are still white. A few in the T6 paint kit caught me out at the start.

To find them I would draw a red square (any bright colour will do), totally covering one half of the texture. Save it and then view the results in the sim. If the problem part still persists, I start again but this time I cover the other half. When the troublesome part is highlighted and I still can not find it, I half that red section again. Doing this will eventually show where it is.

I did this once for the P51 and identified 2 pixels, that held the colour for the underside of the dash on the Virtual Cockpit.


To speed things up, you may want to install Modelconverter X.. It loads much faster than FSX and P3D. I find it very usefull for lineing up liveries and decals.

Steve.

Ok, I make some tests ...

However, How to load my plane in modelconverter ? ( I'm at work ... )

You'll have to be at home to download and install it.

Once installed, you run it and click on the "Import" button on top left side of the menu. You then have to navigate to the .mdl file. For the 182 it would be FSX\SimObjects\Airplanes\A2A_C182\model\c182.MDL

After that you choose your paint from the "Livery" selection drop-down gadget, on the bottom right of the tool bar.

Steve.

EXTRA: You can re-fresh the scene in ModelconverterX, by clicking the two small green arrows, on the left of what looks like a red tea pot, after each fresh save of the texture. Click it twice as sometimes it is stubborn and does not re-fresh on the first click.

Hi Folks,

Yeah - MCX - the only way to paint... Didn't think the refresh worked - I normally just swap liveries - have to give that another try - thanks.... that would cut my load times in half...

Regards,
Scott


Sent from my iPhone using Tapatalk

Since I'm swapping, back and fore between Photoshop to MCX, the first click will just switch the focus for Windows. Sometimes I have to click three times to get MCX's attention.

I didn't know modelconverter was able to open aircrafts ... i've lost so many time switching to P3D ...

I will try this week-end and i will let you know.