Something to note, guys, which I've spotted in the repaints released so-far (if it matters to you).
When you select the "racer" canopy option, it changes some of the modeling of the section of fuselage just behind the rear cockpit, not just the windscreen/canopies themselves. One of the changes is on the side of the fuselage, centered on the baggage door. When you select the "racer" canopy option, it changes the standard baggage door to the fully-rectangular baggage door (one of the design aspects of the AT-6F and SNJ-6, which were the two production examples that had the all-around clear rear windscreen as seen with the racer option (the later Harvards had this same baggage door/compartment design as well)). When selecting the "racer" option, it also changes the rear windscreen fairing modeling. So not only do you have to apply the markings to the standard section of the fuselage textures, but there must be an additional spot or two on the texture sheet just for the rectangular baggage door/rear windscreen fairing which should also receive attention for everything to display properly when the "racer" canopy is selected. Here are some quick screenshots to illustrate (I'm sorry to use your repaints as an example, Marius, I already love them just fine as is - they're both gorgeous!):
